Tecfluid MX4 For FLOMID Series Manual de usuario descargar pdf (Pagina 23)

3.2 Cable installation

The following points must be taken into account:

 The cable should be installed in a conduit or should be securely fixed, given that

movements of the cable can induce reading errors.

 The cable should be placed as far as possible from sources of electrical noise such as

switching gear and electrical machines.

 The maximum length of the connection cable depends on the fluid conductivity. For

liquids with a conductivity higher than 500µS/cm cable length can be up to 150 m.

3.3 Cable connection to sensor

For the sensor connection, first loosen the cable gland to allow the cable to slide in it.

 Make sure that the two fixing screws of the cover do not protrude inside the cover (this

avoids damaging the o-ring of the sensor neck).

 Apply a few Vaseline on the sensor neck to aid inserting in the cover, specially on the o-

rings.

Connector cover

Male connectors

Sensor neck

Fixing screws

REMOTE SENSOR

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 63 64

Rosman Mohamed 12 Jul 2024 | 01:50:59

thank you

Tecfluid MX4 For FLOMID Series Manual de usuario Pagina 23