Tecfluid CU Series Manual de usuario descargar pdf (Pagina 40)

It is an intuitive tool to verify that the instrument has been installed and programmed

correctly.

By means of the "Record" button, you can store data in different computer files, which can

then be processed by other software.

11.5 Simulation

If the converter CU100 is not available, the software can be used in simulation mode.

To do this, press the button "Enter" in the simulation section on the initial screen (see figure

on page 36).

Tabs "Installation" and "Programming" will open.

You will be able to calculate the distance between the transducers and change the data,

although they may not be sent to the converter.

ASSOCIATED SOFTWARE WINSMETER CU

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 46 47 48

Sin comentarios

Tecfluid CU Series Manual de usuario Pagina 40